A quartet of legislators has introduced a measure to give the U.S. Food and Drug Administration more authority in the medical device approval process to keep potentially harmful products from coming to market. The Safety Of Untested and New Devices Act of 2012 (SOUND Devices Act) would allow the FDA to reject a manufacturer’s application for a new medical device based on the approval for a similar product already in the marketplace – if that device has been subject to a safety recall.
The bill was submitted by Reps. Edward J. Markey (D-Mass.), Henry A. Waxman (D-Calif.) and Jan Schakowsky (D-Ill.), all of whom serve on the House Committee on Energy and Commerce’s Subcommittee on Oversight and Investigations. The fourth sponsor, Rep. Rosa DeLauro (D-Conn.), is a member the appropriations committee’s Subcommittee on Agriculture, Rural Development, the FDA and related agencies.
The legislation is in response to the recent recalls, civil lawsuits and warnings about defective medical devices, like metal-on-metal hip implant devices and synthetic surgical mesh products. To date, two metal-on-metal total hip replacements and one metal-on-metal hip resurfacing system have been recalled in the U.S. in 2008 and 2010 because they had a high rate of replacement in patients. New research being presented today at the American Academy of Orthopaedic Surgeons annual meeting in San Francisco shows that these faulty hip joints pose adverse health effects for some patients even after they are removed. Continue reading
A renown seat safety expert has called on the U.S. Consumer Product Safety Commission and the Veterans Administration to institute random spot checks to ensure that mobility scooter and other powered wheelchair devices intended for the disabled meet minimum voluntary safety standards – and publicize any compliance failures to warn the public. Dr. Kenneth J. Saczalski, who has been at the forefront of seat strength issues for decades, made his call to action today at a meeting of the Society for the Advancement of Materials and Process Engineering meeting in Fort Worth, Texas.
Saczalski was retained by Miami attorney David Bianchi on behalf of the family of Carolyn Sorenson to determine what caused a scooter seat back to break in a products liability case against the U.S. distributors of the Daytona GT3 Electric Scooter. In January 2009, 64-year-old Sorenson died from positional asphyxiation in the trash room of her condominium building, when the plastic molded seat of her mobility scooter fractured and collapsed, causing her to fall backwards. Sorenson’s lower half remained belted in what was left of the seat, while her upper torso was wedged behind her against the door frame, according to police reports. Continue reading
FDA News, a purveyor of U. S. Food and Drug Administration regulatory and international standards compliance newsletters, books, special reports and conferences, gathered the medical devices industry to a come-to-Jesus meeting last week and the warnings were stern: quality has been low and the number of U.S. Food and Drug Administration warnings and recalls is high. Medical device manufacturers haven’t met the bar for quality control and the regulations are about to get a whole lot tighter.
Presenters at the three-day conference on risk management and post-market surveillance reeled off a list of unhappy statistics:
Adverse events are growing faster than the market. Infusion pumps, automated external defibrillators and catheters produced 65 percent of the serious adverse events from 2005-2009, according to FDA data.
In 2010, the FDA issued 89 warning letters for Quality Systems deficiencies.
Nearly one-third of all medical device recalls occur as a result of design and/or manufacturing defects and root cause analyses shows that there are wide gaps in product design, manufacturing process control, and supplier management. (The FDA can also require a recall based on a wide variety of non-conformance issues including bad record-keeping, failing to report death and injuries associated with a device and failure to establish a corrective action plan.) Continue reading